ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º Western Digital Corp. WD1006V-SR1,SR2 º ÌÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ͹ º º º J6 J3 J4 J5 J1(SR2) º º J1: Floppy ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ÉÍÍÍ º º J5: HD Control ³.... 1:::: 1:::: 1:::::: 1:::::: ³º º º J4: HD0 Data ³ ³º º º J3: HD1 Data ³ :::W1 ..W2 ³º º º J6: HD LED ³ ..W3 ³º º º ³ ..W4 ³º º º ³ ³º º º ³ ..W5 :W6 ³º º º ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ Ú¿ ÚÄÄÙº º º ÀÄÄÄÄÄÄÄÙÀÄÄÄÄÄÄÄÄÄÄÄÄÙ º º º INTERFACE: ISA(AT)->ST412(RLL) º º CONTROLS: 2 Floppy Drives (SR2 only) (360KB, 720KB, 1.2MB, 1.44MB) º º 2 Hard Drives º º º º º º W1: 1-2: Hard Disk Mode: Latched Mode: OFF º º Non-Latched Mode: ON º º º º 3-4: Error Correction Code: *4-Byte ECC OFF º º 7-Byte ECC: ON º º º º 5-6: Onboard Cache: Cache Enabled: OFF º º Cache Disabled: ON º º º º W2: Onboard BIOS: BIOS Enabled: OFF º º BIOS Disabled: ON º º º º W3: Hard Drive I/O Address: *Primary Address: OFF º º Secondary Address: ON º º º º W4: Floppy Drive I/O Address: *Primary Address: OFF º º Secondary Address: ON º º º º W5: Dual Speed Floppy Support: Single Speed Drives: OFF º º Dual Speed Drives: ON (note 1) º º º º W6: Ground Connection: Bracket not connected to Board Ground: OFF º º Bracket connected to Board Ground: ON º º º º (note 1) DO NOT mix single & dual speed drives in the same system. º º º º (* defaults) º ÇÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿ ADDITIONAL INFO ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄĶ º º º Low Level Format can be done on boards that have their BIOS enabled º º by utilizing the DOS DEBUG command g=cc00:5. º º º º It is recommended that a Format be accomplished when changing from a º º WD1003-XXX controller to the WD1006V type controller. º ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ